Frequency Selection; Frequency Step Selection - Kenwood TM-241A Instruction Manual

5-2-2. Frequency Selection
You can change the dial frequency while in the VFO
mode. The frequency can then also be stored in
memory, or in the call channel using the techniques
that will be described in this manual.
VFO mode
VFO key
MR key
VFO key CALL key
CALL key
MEMORY channel mode CALL channel mode
MR key
VFO Mode Operation Frequency Selection
Press the VFO/MPV key to select the VFO mode.
Rotate the tuning control or press the microphone
UP/DWN switches to select the desired frequency.
Memory Channel Selection
Press the MR/M key.
Rotate the tuning control or press the microphone
UP / DWN switches to select the desired memory
channel.
CALL Channel Selection
Press the CALL key to select the Call channel.
Nr@ Pre
5-2-3. Frequency Step Selection
The frequency step is indicated in the chart below.
STEP
§210215220212.5225
To select the desired tuning or scan step size use the
following procedure:
1. Press the VFO/MP V key to select the VFO mode.
2. Press the F key momentarily. The F indicator should
light in the display.
3. Press the REV/STEP key within 10 seconds of pressing
the F key. The current frequency step size will be
displayed.