Kenwood TS-450S Instruction Manual page 75

If a DSP-100 is connected to each of the transceivers, connect as shown in Figure 2.
DSP-100
88 maa )
ee HED s
20
6-Pin cable
Figure shows TS-450S
Note >
This function does not work if the DSP-100 power is off.
4-20-2. Function setting
Perform the "data transfer enable" power on function #17 on page52.
Refer to the TS-850S instruction manual for its power on function setting.
4-20-3. Data transferred
Transferrable data that can be transmitted includes the following:
RX frequerncy and mode can be transferred from one transceiver to onother.
4-20-4. Operation
To transfer data from Memory Channel 00 of one transceiver to Memory Channel 00 of the other transceiver:
1. Press the M.IN key on the master/transmitting transceiver.
2. Select Memory channel 00 using the M.CH/VFO CH control.
3. Press the M.IN key to start the transfer.
When the transfer is complete, the slave/receiving transceiver will announce in Morse code "QSL".
To transfer data from VFO of one transceiver to the VFO of the other transceiver:
1. Perform power on function 18 on page 52.
2. Set the desired frequency and mode in the active VFO on the master/transmitting transceiver.
3. Press the M.IN key.
4. Select Memory channel 00.
5. Press the M.IN key to start the transfer.
When the transfer is complete, the slave/receiving transceiver will announce in Morse code "QSL".
75