Kenwood TS-450S Instruction Manual page 59

4-12-8. Memory Channel Selection
Hi Tochange between the channels stored in memory
HiTo change between the empty channels
1. When VFO operation is performed, press the M/V key. The
display shows the last accessed memory channel.
np
. Activate the 1MHz key (the 1MHz indicator will light) and
rotate the M.CH/VFO CH control to switch between the
channels stored in memory.
id
To return to VFO operation, press the M/V key.
Note
If there is nothing in the memory channels, and the
M.CH/VFO CH control is rotated, "check" is output from the
speaker in Morse code.
a
. Press the M.IN key to enter the memory scroll mode.
Although the display frequency is changed, the frequency
set before the M.IN key was pressed is used for actual
reception.
N
Activate the 1MHz key (the 1MHz indicator will light) and
rotate the M.CH/VFO CH control to switch between the
empty channels. You can also do this with the numeric
keys.
3. To cancel the memory scroll mode, press the CLR key.
Notes
1. If all the memory channels are full, and the M.CH/VFO CH
control is rotated, "check" is output from the speaker in
Morse code.
2. If achannel stored in memory is specified with a numeric
key, "check" is output from the speaker in Morse code.
59