Kenwood TS-450S Instruction Manual page 33

TRANSMISSION
The center frequency is displayed.
pober M.CH/VFO CH NOTCH saL
: era
| ' ' nn ee |
Sea
ii
att eee
O
Or
a @ z 0;
ies
wm sexo auto iad
RITKIT-@+ IF SHIFT AF —Q-8F
t+ 0 Ss wserf] ae ||| od tah he
_ Ib te
ae
7 T i s Te
or
ao:
' 0
"0 qocemoernor
"O
Connect a microphone to the MIC jack.
Turn on the DC power supply and then turn the
transceiver's power switch ON.
A frequency will appear in the display.
Select the desired frequency.
Select AM with the MODE key.
Turn the PWR control fully clockwise.
Press the microphone PTT switch, or
REC/SEND switch to SEND(=).
Before transmitting check the frequency for activity so
that you do not interrupt another QSO.
set the
Adjust the CAR control so that the meter indicates as
shown Fig.1.
Speak into the microphone and adjust the MIC gain
control so that the meter indicates as shown Fig.2. on
voice peaks.
Note
If the MIC gain control is advanced too far clockwise,
the transmit signal will become distorted.
i8) [6] 9
40W
AO
S135 7 9 20 40 ue
LiL ITT LTT) | isisisielejsleieleielsieleieiel
pwro__i) 28 he so
es eee eee See Ne
Fig.1
80W
Sa a
S335 7 9 20 40 sab
TTT TTT TT leleleialejelejelelajay
pwet__i! ase Oy
Se ee ee ee a Dg
Fig.2
33