Kyocera TASKalfa 6053ci Hardware Installation And Reference Manual page 199

Fax Settings > Default fax settings
Item
FAX Rings(Normal)
Rings (TAD)
Rings(FAX/TEL)
RX Setting
Remote SW Dial
Reception Port
ECM RX (Port1)
ECM RX (Port2)
RX Start Speed (Port1)
RX Start Speed (Port2)
If the reception method is fax automatic reception, the number of rings until
the machine answers a call can be changed as needed.
NOTE
This setting does not appear in some regions.
If the reception method is FAX/Answering Machine Auto Switch Reception,
the number of rings until the machine answers a call can be changed as
needed.
NOTE
This setting does not appear in some regions.
If the reception method is FAX/TEL Auto Switch Reception, the number of
rings until the machine answers a call can be changed as needed.
NOTE
This setting does not appear in some regions.
Select the reception mode.
Value: Auto (Normal), Auto (FAX/TEL), Auto (TAD), Manual, Auto (DRD)
If Auto (DRD) is selected, select the DRD Pattern.
Value: Pattern 1 (Normal Ring), Pattern 2 (Double Ring),
Pattern 3 (Short-Short-Long), Pattern 4 (Short-Long-Short)
DRD reception mode is available for some countries.
FAX Reception (page 4-2)
Manual Reception (page 4-4)
DRD Reception (Available for some countries.) (page 5-46)
To start fax reception by operation from the connected telephone set, use the
following operation.
Value: 00 - 99
Remote Switch Function (page 5-50)
*1
You can make one of the 2 phone lines a receive-only line.
Value: Off, Port 1, Port 2
Reception Port Selection (page 9-3)
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International
*1
Telecommunication Union) that retransmits data when an error occurs. Fax
machines that have ECM mode check for errors as they communicate,
preventing distortion of the image due to noise on the line and other
conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received
*1
correctly. In that case, set a lower RX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Description
8-12