Step Flanger; Hexa-Chorus - Roland VERSELAB MV-1 Parameter Manual

25 Step Flanger

This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms of
a note-value of a specified tempo.
L in
Step Flanger Step Flanger
Feedback
Feedback
Step Flanger Step Flanger
R in
Parameter Value
Filter Type OFF, LPF, HPF
200, 250, 315, 400,
500, 630, 800, 1000,
Cutoff Freq 1250, 1600, 2000,
2500, 3150, 4000,
5000, 6300, 8000 [Hz]
Pre Delay 0.0–100.0 [msec]
Rate OFF, ON
(sync sw)
Rate 0.05–10.00 [Hz]
(Hz)
Note
Rate
(note)
&
"Note"
(p. 51)
Depth 0–127
Phase 0–180 [deg]
Feedback -98–+98 [%]
Step Rate OFF, ON
(sync sw)
Step Rate 0.10–20.00 [Hz]
(Hz)
Note
Step Rate
(note)
&
"Note" (p. 51)
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Balance D100:0W–D0:100W
Level 0–127
Balance D
L out
2-Band EQ 2-Band EQ
Balance W
Balance W
R out
2-Band EQ 2-Band EQ
Balance D
Explanation
Type of filter
OFF: No filter is used.
LPF: Cuts the frequency range above the
Cutoff Freq
HPF: Cuts the frequency range below the
Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct sound
until the flanger sound is heard.
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Frequency of modulation
Depth of modulation
Spatial spread of the sound
Adjusts the proportion of the flanger sound
that is fed back into the effect. Negative (-)
settings will invert the phase.
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Rate (period) of pitch change
Gain of the low range
Gain of the high range
Volume balance between the direct sound (D)
and the flanger sound (W)
Output Level

26 Hexa-Chorus

Uses a six-phase chorus (six layers of chorused sound) to give richness
and spatial spread to the sound.
Balance D
L in
Hexa Chorus Hexa Chorus
R in
Balance D
Parameter Value
Pre Delay 0.0–100 [msec]
Rate OFF, ON
(sync sw)
Rate 0.05–10.00 [Hz]
(Hz)
Note
Rate
(note)
&
"Note" (p. 51)
Depth 0–127
Pre Delay Deviation 0–20
Depth Deviation -20–20
Pan Deviation 0–20
Balance D100:0W–D0:100W
Level 0–127
MFX Parameters
L out
Balance W
Balance W
R out
Explanation
Adjusts the delay time from the direct sound
until the chorus sound is heard.
If this is ON, the rate synchronizes with the
tempo of the rhythm.
Frequency of modulation
Depth of modulation
Adjusts the differences in Pre Delay between
each chorus sound.
Adjusts the difference in modulation depth
between each chorus sound.
Adjusts the difference in stereo location
between each chorus sound.
0:
All chorus sounds will be in the center.
20: Each chorus sound will be spaced at 60
degree intervals relative to the center.
Volume balance between the direct sound (D)
and the chorus sound (W)
Output Level
25