Table of Contents
Advertisement
27-5
Parameter setting
To display this screen, click the [Setting] button of the "Parameter Setting" item on the electricity charge ap-
portionment main screen.
Setting of the model name of the unit which is to perform electricity charge apportionment calculation and
the externally linked devices are performed by means of this screen.
Since model name setting is necessary in electricity charge apportionment calculation, perform it certainly.
(Normally, if scanning is performed, the model name is set automatically.)
Selects the unit (outdoor unit, indoor unit, RB unit) which is to be set from the list hierarchically dis-
played in tree view site, adaptor, refrigerant, and R/C group order.
Expand (collapse) mark
Not displayed below the
clicked node.
Icon representing the set-
ting state of a unit. See .
Expand (collapse) mark
Collapsed state
When clicked, hidden nodes
are displayed.
Note
The "Tree View" may not be displayed on the screen depending on the contents. In this case, display it
by scrolling the screen using the scroll bar at the side of the screen.
Copyright© 2013-2015 Fujitsu General Limited. All rights reserved.
255
5
Site node (highest level)
Adaptor node
Refrigerant node
Outdoor unit
R/C group node
Indoor unit which is selected
RB unit
Advertisement
Table of Contents
