Standard Remote Control Operation Prohibit Setting - Fujitsu UTB-GCA Operating Manual

4-2. STANDARD REMOTE CONTROL OPERATION
PROHIBIT SETTING
ACL
CLOCK
ADJUST
DAY
TIMER
MODE
TIMER DAY OFF
COPY
In validate (or do not able to make) the operation settings from the relevant standard remote control-
ler by pressing the central remote controller. The following shows the centrally controlling items that
can be performed.
• ......... Invalidate (or do not able to make) all operation settings from the relevant standard
remote controllers.
• .......... Invalidate (or do not able to make) all timer settings (OFF / ON / WEEKLY) from the
relevant standard remote controller.
• .......... Invalidate (or do not able to make) mode operation setting from the relevant standard
remote controller.
• .......... Invalidate (or do not able to make) temperature setting from the relevant standard
remote controller.
• .......... Invalidate (or do not able to make) filter reset operation from the relevant standard
remote controller.
• .......... Invalidate (or do not able to make) ON / OFF operation of the indoor units from the
relevant standard remote controller.
Several of the centrally controlling items can be set simultaneously, except
operation settings of the relevant standard remote controller invalidate (wireless) or cannot be made
(wired). The started centrally controlling items can be set only when DIP-SW 2-5 "enable / disable
setting of the standard remote controller prohibition function" has been set to enable.
Enter the control mode to select the central control
number (the indoor units), so that the relevant stan-
dard remote controllers whose centrally controlling
items need to be set are also selected.
Refer to "3-3. CONTROL MODE" for details about
control modes.
TIME
TIMER MEMORY CENTRAL
DELETE OPERATION CONTROL
TIMER MEMORY GROUP
SET SETTING SETTING
CHECK
ENERGY
BACK
ZONE
SAVE
SET
FILTER
ON OFF
RESET
DELETE
TEST
MASTER
CONTROL
FAN
TEMP .
ANTI
CONTROL
FREEZE
. If is set, all
23