62
Series 90PLUS Operator's Guide
ADJUSTING THE PLATEN GAP
Blue
Lever
The gap between the print head and the platen can be adjusted to accommodate
the thickness of different paper. If the gap is not set properly, the characters
can smudge, the print head can jam, and the density of the characters will be
less than ideal.
Adjust the print head gap by moving the blue lever, located to the left of the
ribbon cassette, to one of three positions. Open the cassette cover to reach the
lever.
Set the gap to one of the following:
Position 1: One-ply paper,
Position 2: Two-ply paper, or
Position 3: Three-ply paper.