Loading And Removing Paper; Installing The New Paper Roll - TransAct Ithaca 90PLUS Series Operator's Manual

LOADING AND REMOVING PAPER

INSTALLING THE NEW PAPER ROLL

This section describes how to load and remove paper. Change the paper when
the READY light flashes orange and green. This indicates that the paper is
low. The printer will stop. You must change the paper for the printer to resume
operation.
Follow these instructions for loading either single- or multiple-ply paper.
Note: If this is a new installation, a receipt roll is supplied with the
printer. If you are changing multiple-ply paper, remove the
journal take-up roll before loading the new roll. See
"Removing the Journal Take-up Roll" on page 33.
1. Open the paper cover.
If you are changing the paper, remove the used supply roll. Do not pull on
the paper to remove unused paper from the printer. Instead, hold the FEED
and RESUME buttons simultaneously. This removes unused paper from
the printer safely.
2. Tear off a clean edge on the new roll and fold the paper straight.
This makes it easier to load the paper.
Setting Up the Printer
27