Coolant Filling; Adblue®/Def Filling - Kohler KDI-TCP 3404 E5 Owner's Manual

4

4.6 Coolant filling

Important
• Before proceeding with operation, read
Warning
• An anti-freeze protection liquid (ANTIFREEZE) - mixed with decalcified water - must be used.
• The freezing point of the refrigerant mixture depends on the amount concentration in water.
•
As well as lowering the freezing point, the antifreeze also raises the boiling point.
•
A 50% mixture is recommended to ensure a general level at protection prevents the formation of rust, galvanic
currents and calcium deposits.
NOTE: Before proceeding with any operation on the engine, stop it and
allow it to cool.
Warning
• Presence of steam pressurized coolant danger of burns.
1. Loosen the cap A and fill the radiator with coolant composed of:
50% ANTIFREEZE and 50% decalcified water.
2. Top liquid up until the pipes inside the radiator are covered by
about 5 mm. Do not overfill the radiator, but leave room for the
coolant to expand.
3. For engines equipped with expansion tank, pour in fluid until
reaching the max level mark.
4. Re-tighten the cap A .
5. After a few hours of operator, stop the engine and allow the liquid
to cool returns to a ambient temperature and check the coolant
level again.
4.7 AdBlue®/DEF filling
NOTE: Refer to the technical documentation of the vehicle.
EN 36
INFORMATION ABOUT USE
Par. 3.2.2 .
Fig. 4.3
Fig. 4.4