Filter Cartridge And Fuel Pre-Filter Replacement - Kohler KDI-TCP 3404 E5 Owner's Manual

INFORMATION ABOUT REPLACEMENTS

6.3 Filter cartridge and fuel pre-filter replacement

NOTE : The fuel filter is situated on the crankcase of the engine or it may be
assembled on the frame of the vehicle.
Important
• Before proceeding with operation, read
Warning
• In case of low use replace il 12 months.
• For disposal of oil filter cartridge and fuel filter refer to
DISPOSAL and SCRAPPING
1. Disconnect the cable A of the water presence sensor C .
2. Remove the water presence sensor C from its cartridge B .
3. Loosen the cartridge B using the appropriate wrench.
4. Lubricate the gasket D of the new cartridge B.
Important
• Do not fill the new cartridge B with fuel.
5. Tighten the new cartridge B (Fig. 6.8) on the diesel fuel filter support
E using the special wrench (tightening torque of 17 Nm ).
6. Tighten the water presence sensor C on the new cartridge B
(tightening torque of 5 Nm ).
7. Reconnect the cable A of the water presence sensor C.
NOTE : Bleeding.
8. Push repeatedly the button G in order to fill the circuit.
NOTE: Click on the icon to play the procedure.
Par. 3.2.2
Par. 6.5
6
Fig 6.9
Fig 6.10
https://youtu.be/eHPkX9yprM4
51
EN