Table of Contents
Advertisement
20
<ARB7055>
En
Load discs with label
surface toward right.
<For PD-0160F>
TO LISTEN TO A COMPACT DISC (CD)
Be sure to read these instructions before operating.
@
Up to 25 discs can be loaded in the rack at one time.
@ The rack's loading slots are numbered consecutively
from the left.
1. Hold the hood by the hook handle. Open the
hood.
The rack will come forward.
2. Load discs, being careful to confirm that the
label surface is on the right side.
3. Press the hook and close the hood.
@ The unit cannot be operated when the hood is
open.
w@ To remove discs:
1. With the unit stopped, open the hood.
2. Remove discs from the rack.
NOTES:
@
The hood cannot be opened during playback, disc search,
and for about 10 seconds immediately following cornple-
tion of playback.
If you attempt to open the hood in
such cases, the "LOCK" message will flash on the dis-
play, in this case, quickly close the hood and wait until
the "LOCK" message disappears before attempting to
open the hood again.
@
Discs cannot be played if loaded with the label surface
to the left. Be sure the label ts on the right side when
loading discs.
Do not attempt to open the hood forcibly.
Open and close the hood gently.
The unit cannot be operated when the hood is open. Be
sure to shut the hood before attempting to operate the
unit.
®@ Take care not to pinch fingers when closing the hood.
Never place your hand or objects inside the unit.
Rack
@
Never place any objects other than discs inside the unit.
@
Load only one disc per rack groove.
Attempting to load more than one disc in a slot may
cause unit malfunction and damage to the discs.
@
Do not use adapters when loading 8 cm discs.
@
/f 12cm and 8&cm discs are loaded in alternate order on
the rack, the changer may have difficulty changing the
discs. If you wish to load 12 cm and 8 cm discs at the
same time, we recommend that 12 cm discs all be loaded
beginning on the left side of the rack, and all 8. crm discs
be loaded beginning on the right side of the rack.
@
When moving this unit, be sure to remove all discs from
the rack, set the power to OFF (STANDBY), and discon-
nect the power cord.
Advertisement
Table of Contents
