Table of Contents
Advertisement
Series: Integrated
Decorative door and bottom-drawer panels layout
1
2
3
12
The dimensions of the panels are indicated in the table and draw-
ings on pages 18-21.
Nevertheless, according to the requirements for aligning with other
kitchen structures, the door panel can be higher than the upper
edge of the refrigerator door, and the drawer panel can be lower
than the edge of the drawer.
The panels must be mounted using special braces which attach
to adjustable devices provided on the door and drawer and with
brackets that anchor and adjust the panel's vertical direction.
Braces, brackets and fixing screws are provided with the appliance
and must be applied to the panel as indicated.
Operate as follows:
To prepare the panels to be mounted on the appliance, follow
these steps, working on the back of the panel.
Door Panel
Trace, a line dividing the panel width in half
Starting form the Bottom edge of the panel, mark the positioning
of the brackets
.
2
Following the corresponding table, mark the external and then
the internal hole
.
3
.
1
Advertisement
Table of Contents
