Table of Contents
Advertisement
1
2
3
4
5
Once the front panel has been adjusted,
check that the gasket has been
repositioned correctly to assure the
door/drawer are closing correctly and
avoid operational errors of the unit.
Mounting panels to the door and the drawer
Once all brackets and small brackets have been applied to the pan-
els, you can begin installing the bottom drawer.
Operate as follows:
Partially tighten the screw to the fixing
Hook the bottom drawer panel starting from the fixings on the bot-
tom
.
2
It is now possible to align panels to adjacent cabinets in height
using the lower alignment brackets,
the screws into position as needed. With the screw slighty tightened,
move the panel sideways to align it to the other panels on the unit or
other adjacent structures.
Depth alignment: working from the inside of the drawer, after lift-
ing up the magnetic seal, adjust the panel position so it is closer to or
further away from the door using the holes
panel using the holes
.
5
Installation Guide
Series: Integrated
.
1
tightening or untightening
3
4
and then secure the
17
Advertisement
Table of Contents
