Caring For The Environment; Cleaning, Sanitization And Maintenance Of The Ice And/Or Water Dispenser (If Present) - Smeg RF376RSIX Manual

Cleaning, sanitization and maintenance of the ice and/or water dispenser (if present)

Important directions for safety and the environment
Pay special attention to correct disposal procedure for all the pack-
aging materials.
The appliance must not be disposed of with urban waste. Contact lo-
cal waste disposal centers for on how to dispose of recyclable waste.
Prior to disposal, cut the power supply cord and make it impossible
to close the door.
During disposal, avoid damage to the refrigeration circuit.
The appliance does not contain hazardous substances for the atmos-
pheric ozone layer, neither in the refrigeration circuit nor in the insulation.
Failure to follow the instructions regarding sanitizing can compromise
the hygienic safety of the water dispensed.
When using the appliance for the first time and every time the filter
is changed, it is recommended to let the water flow in the circuit using
the "Manual Cleaning" and discard the ice produced in the first 24
hours.
If the water dispenser has not been used for more than 4/5 days, it is
advisable to clean the circuit and run off the first litre of water.
Reposition the removable water dispenser (if present), ensuring your
hands are hygienically clean.
Clean the ice bucket or drawer regularly but using only drinking
water.
The filter must be changed when indicated on the control panel
or when the ice/water dispenser has not been used for more than 30
days.
With each filter replacement, sanitise the ice and/or water distribu-
tion system using a food grade disinfectant (with sodium hypochlo-
rite), which does not alter the characteristics of the materials, or use
the "Sanitising Kit" available from the After-Sales Service. Rinse with at
least 2 litres of water before use.
Only original spare parts supplied by the manufacturer should be
used when replacing components in the ice and water dispenser.
Any work on the appliance must be carried out by a qualified tech-
nician or the After-sales Service.

Caring for the environment

1
1.2
1.3
3