Table of Contents
Advertisement
4
Appliance switching on and off
4.2
How to adjust the temperature for different requirements
Refrigeration Compartment
The temperature shown can vary slightly in re-
spect to the set temperature following frequent
openings of the doors or insertion of room tem-
perature foods or large quantities of foods.
6 to 12 hours are necessary to reach the select-
ed temperature.
4.3
Ice Maker Activation
Do not activate the Ice Maker unless the appli-
ance is connected to the water mains.
4.4
Information and malfunction messages on the display
10
Each model has been carefully tested before leaving the factory and
is adjusted in such a way to ensure high performance and low con-
sumption. Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is possible to modify the
set temperatures as follows:
From +2°C to +8°C (from 35.6°F to 46.4°F), the recommended preset
temperature is +5°C (41°F).
To adjust the temperature use the Up/Down buttons
Upon touching these buttons the newly set temperature will appear in
the display. To modify this temperature, use the buttons until reaching
the desired temperature.
Freezer Compartment
From -15°C to -22°C (from 5°F to -7.6°F), the recommended tempera-
(Multizone)
ture is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons .
Upon touching these buttons the newly set temperature will appear in
the display. To modify this temperature, use the buttons until reaching
the desired temperature.
In case the compartment is used as refrigerator or 0°C compartment
(Multizone function) the recommended and preset temperatures will
correspond to those indicated for the respective compartments.
The Ice Maker button
activation of the automatic icemaker.
The button is illuminated when the icemaker is functioning.
A prewash of the hydraulic circuit should be performed before acti-
vating the Ice Maker for the first time. To do this touch at the same time
buttons Enter
After a few minutes the Ice Maker can be activated.
An integrated control system provides information through lighted sig-
nals or text messages visualized on the display.
The information signal is always visualized with a fixed text message,
while a malfunction signal is visualized with blinking text.
The sound signal that accompanies some malfunction signals can be de-
activated by pressing the Alarm button
The list of malfunction signals is located at the back of this manual.
located on the main control panel permits
and Ice Maker
.
on the main control panel.
.
Advertisement
Table of Contents
