Table of Contents
Advertisement
5. Using the Scanner Function
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Resolution], see p.263 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.298 "Administrator Settings".
Specifying the scanning side according to the original (Type 2 model)
If you are using the Type 2 model, you can specify the machine to scan both sides of original
automatically using the ARDF.
This section describes how to specify the scanning side according to the current original.
1.
Press [Original].
2.
Press the [ ][ ] keys to select the desired scanning method, and then press the [OK] key.
Select the sides of the original (1 side or 2-sides) to scan. When scanning 2-sides, select the page
and binding orientations according to the original.
• You can press the [Escape] key to exit to the previous level of the menu tree.
• If 2-sided scanning is specified, you must use the ARDF (scanning will not be possible with the
exposure glass).
• You can change the machine's default [Original] setting to always scan specific sides of originals.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed.
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Original], see p.263 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.298 "Administrator Settings".
194
Advertisement
Table of Contents
