Table of Contents
Advertisement
5. Using the Scanner Function
Using the [Pause/Redial] key
Press the [Pause/Redial] key to select the last used destination.
• When you specify a scan destination, the machine's scan settings change automatically according
to the information registered for that destination in the Address Book. If necessary, you can change
the scan settings using the control panel.
• The [Pause/Redial] key is not effective for the first scan job after the machine is turned on.
• To select destinations not registered as Quick Dial entries, use the [Address Book] key.
• For details about how to specify destinations using the [Address Book] key, see p.183 "Basic
Operation for Scan to E-mail/FTP/Folder".
Specifying the scan destination from an LDAP server
This section describes how to select a destination registered on the LDAP server.
• To search for a destination from an LDAP server, the LDAP server must be registered in advance,
and [LDAP Search] must be enabled under the LDAP server settings.
186
CMF142
CMF143
Advertisement
Table of Contents
