Warranty - Genie GCL-LJ Series Manual

Commercial Operator Limited Warranty
The Genie Company ("Seller") warrants to the original purchaser of the GCL-LJ commercial door operator
("Product"), subject to all of the terms and conditions hereof, that the Product and all components thereof
will be free from defects in materials and workmanship under normal use for the following period(s),
measured from the date of installation.
Two (2) years or When the Operator exceeds 20,000 cycles of operation, as measured by the integrated
cycle counter contained in the Operator.
Seller's obligation under this warranty is specifically limited to repairing or replacing, at its option, any
part which is determined by Seller to be defective during the applicable warranty period. Any labor
charges are excluded and will be the responsibility of the purchaser.
This warranty is made to the original purchaser of the Product only, and is not transferable or assignable.
This warranty does not apply to any unauthorized alteration or repair of the Product, or to any Product or
component which has been damaged or deteriorated due to misuse, neglect, accident, failure to provide
necessary maintenance, normal wear and tear, or acts of God or any other cause beyond the reasonable
control of Seller.
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EITHER EXPRESSED OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
IN NO EVENT SHALL SELLER BE RESPONSIBLE FOR, OR LIABLE TO ANYONE FOR, SPECIAL, INDIRECT,
COLLATERAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL DAMAGES, even if Seller has been advised of
the possibility of such damages. Such excluded damages include, but are not limited to, loss of goodwill,
loss of profits, loss of use, cost of any substitute product, interruption of business, or other similar indirect
financial loss.
Claims under this warranty must be made promptly after discovery, within the applicable warranty
period, and in writing to the Seller or to the authorized distributor or installer whose name and address
appear below.
The purchaser must allow Seller a reasonable opportunity to inspect any Product claimed to be defective
prior to removal or any alteration of its condition. Proof of the purchase and/or installation date, and
identification as the original purchaser, may be required.