Genie GCL-LJ Series Manual page 18

Monitored Edges, Wireless -
Actuating the operator by using constant contact on the CLOSE button will override non-functioning
external reversing devices, including sensing edges.
L'activation de l'operateur en util isant un contact constant sur le bouton FERMER annulera les dispositifs
d'inversions externes, y compris les systèmes de détection des bords.
MillerEdge® Wireless Monitored Sensing Edge Installation
Right-hand installation shown, left-hand installation mirrored
1. Mount Wireless Edge Receiver adjacent to operator.
2. Route MEL wireless receiver wires into operator electric box using suitable conduit and clamp systems.
3. Attach MEL wireless receiver power wires (blue/yellow) to external transformer as shown below.
4. Attach MEL wireless receiver trip wires (white/white) to STB terminals on control wire terminal strip.
5. Mount MEL wireless transmitter to bottom edge of door per MEL instructions.
6. Install wires to STB terminals in operator.
16
WIRE THE OPERATOR
WARNING
!
AVERTISSEMENT
!
T3 Safety Edge
MEL-II
Transmitter
(Optional)
Operator Terminal Strip
White
White
Transformer 36238A
MEL-II
Power
MEL-II
Receiver
MEL-II-8 pin connector
CH 1 CH2
PWR
Yellow
Blue