Programming Additional Remote Controls (Optional) - Genie GCL-LJ Series Manual

NOTE: The following instructions are for remote control transmitters purchased
separately or if remote(s) require re-programming.
NOTE: Each programming step has a 60 second time limit for completion after
the function is initiated. After 60 seconds, two LEDs will illuminate blue indicating
time has expired and the step must be re-started. Restart the step as many times as
necessary to complete the programming.
1. Remove the battery's protective film from the remote by
pulling straight out if tab is present.
2. Press and hold the SET/PRGM button on the operator for 2-5
seconds.
• The round LED will turn blue. Release button.
• The long LED will then flash purple.
3. Stand at least 5 feet away from operator and slowly press
and release the desired button on the remote two times.
4. Both operator LEDs will flash and turn off indicating the
remote has been programmed.
5. Press the desired remote button again.
6. The operator should run.
To program the same remote for other garage door operators, repeat
the steps above using one of the other remaining remote buttons.
REPEAT STEPS 1 TO 4 FOR EACH OPERATOR AND REMOTE
NOTE: It is possible to press the remote button too quickly or lightly. If the
LEDs do not go off, press the remote button several more times to achieve
confirmation.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR
OPERATOR IS READY TO USE.
See page 33 of this manual to erase remote devices from memory.
PROGRAMMING REMOTE CONTROLS
1. Enter Programming Mode
Solid Blue
Flashing Purple
2. Press Remote Button Twice
1-2-3 or 4 Button Transmitters
*
Flashing
OPEN CLOSE STOP
* Pressing any button on the O/C/S transmitter will program
operator for Open/Close/Stop Operation
3. Test Remote
OPEN CLOSE STOP
PRESS
&
RELEASE
29