Programming Remote Controls; Lost Or Stolen Remote; Multi Button Remote Programming - Genie 1022 Owner's Manual

la. Single Button Remote Programming.
• Locate "Learn Code" _; button and indicator
LED on the power head (Fig. 7-1!.
• Press and release Learn Code button.
-indicator LED will blink RED at a rate of twice
..per second.
• Within 30 seconds, push remote control
button once.
-indicator LED will stop blinking and stay ON.
• Press remote control button again.
- Red LED will go out. Remote is now
programmed and ready for use.
• Press remote control button again, door will move.
lb. Multi Button Remote Programming.
@s_#ned fO_ _ use wf#_ doos tbs c_nno_
TE: hmxj t'_'a_bu s o_'_ pow_.fr he,_d
• For each button.
- Program each button separately using the
Single Button Remote Programming steps.
2. Operating.
• Press remote button once.
- Door will move.
• Press button again.
- Door will stop.
• Press button again.
- Door will move in opposite direction.
_0 T_E: _:_e d,:_o'_v_,'H:i_o7::_. ,_ _::_;_,_ c:_ f_; _ ,_ #_e
f_._@open or f_.#!y ck;_sed posR:<_n
1. Clear memory.
• Press and hold learn code button (on power
head) for 10 seconds or until the red blinking
indicator LED goes out.
• Program remaining or new remote controls as
done previous!y. Your door opener will no
longer recogmze any signal received from the
missing remote control, or any other which has
not been reprogrammed.
This device complies with FCC Part 15 and RSS 210
of Industry Canada. This equipment has been tested
and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which may be determined by turning the
equipment OFF and ON, the user is encouraged to
try to correct the interference by one or more of the
following measures:
, Re-orient or relocate the receiver antenna.
, Increase the separation between the opener
and receiver.
, Connect the opener into an outlet on a circuit
different from that to which the receiver is
connected.
Consult _our local dealer.
LED Open
Indicator Light Open Set Limit
,\ Travel Limit Button
\
To
Garage Door
Up Force
OPEN
Control
ustment
LEARN MANUAL LIMIT FORCE
' i
BCt_oe n CODE Close Close C_OSE D_ownF ....
Travel Limit Bet Limit Control
Button Adjustment
I
PN#3642036534,02/26/2010 REV. 1
23