Table of Contents
Advertisement
1-3. Functions of Internal Switches
MPU-79 Board
. S1, S2, S3, S4 These switches are not used.
Normally set to "OFF".
Factory-setting is "OFF".
. S5 (RESET)
This is not used for normal operation.
. S6 (BUZZER ON/OFF)
When this switch is turned "ON", buzzer sounds by the
input CALL signal.
Normally set to "ON".
Factory-setting is "ON".
. S7 (REMOTE MODE 1)
S8 (REMOTE MODE 2)
Used to select mode for the REMOTE connector on the
connector panel.
CMD : Camera control command mode
ISR : Interactive status Reporting command mode
n
Be sure to set S7 and S8 to the same mode.
Factory-setting is "CMD".
CN1
S7
(REM MODE-1)
S5
(RESET)
CN7
ON
OFF
S6
(BUZZER ON/OFF)
MPU-79
BOARD ( A SIDE )
RCP-730
RCP-731
CN2
S8
(REM MODE-2)
IC10
S1 S2 S3
S4
CN6
1-3. Functions of Internal Switches
1-5 (E)
Advertisement
Table of Contents
