Checks On Completion Of Installation; Description Of On-Board Switches And Leds - Sony MKS-8010A Installation Manual

1-10. Checks on Completion of Installation

1-10-1. Description of On-board Switches and LEDs

n
The number shown in the parentheses ( ) indicated the address on the circuit board.
FP-141 board (MKS-8010A)
1
S106 S107 S108
2
A
<LED>
D100 to D103 (B-1) : MAIN CPU status LED
Main CPU status indication.
Used only for production in the assembly factory.
D104 (B-1) : SIO ACT
Flashes while the communication with the equipment that
is connected to the EDITOR PANEL terminal is in
progress.
D105 (B-1) : SBUS ACT
Lit while the communication with the equipment that is
connected to the REMOTE terminal is in progress.
D106 (B-1) : LAN ACT
Lit while the communication between the Main CPU
module and the MPU-302B board is in progress.
D107 (B-1) : LAN 100M
Lit while the 100 Mb/s communication with MENU CPU
is in progress.
D108 (C-1) to D115 (B-1) : C01 to C08
CTRL terminal communication IC status indication.
Used only for production in the assembly factory.
D116 (D-1) to D123 (C-1) : C11 to C18
PERIPH terminal communication IC status indication.
Used only for production in the assembly factory.
CCP-8000 IM
D107 D106 D105 D104 D115 D114 D113 D112
D103 D102 D101 D100 D111 D110 D109 D108
S103 S104
S100 S101
D132-D147
B
D123 D122 D121 D120
D131
D119 D118 D117 D116
D129
S105
S102
D127
D125
D148-D163 D164-D179
C
D124 (D-2) : SBUS CH1
Lit when an equipment is connected to the REMOTE
terminal.
D125 (D-2) : SBUS RUN
Displays the status of the circuit for processing a signal in
the REMOTE terminal. Lit during a normal operation.
D126 (D-2) : SBUS TX
Flashes while transmitting the communication data to an
equipment that is connected to the REMOTE terminal.
D127 (D-2) : SBUS RX
Flashes while receiving the communication data from the
equipment that is connected to the REMOTE terminal.
D128 (D-1) : HD
Lit when the reference signal that is input via the REF IN
terminal is an HD signal.
D129 (D-1) : REF OK
REF IN signal presence/absence status indication.
Lit when the reference signal is input via the REF IN
terminal.
D130 (D-1) : MCONFIG
Lit when the direct configuration mode is performed.
Used only for production in the assembly factory.
D130
D128
D126
D124
D E
A side/Component side
1-21