Locations and Functions of Parts
Front Panel
MKS-R4020
MKS-E1620
LCD buttons
When connected to a system controller, these buttons can
be used as source selection buttons, destination selection
buttons, or level selection buttons. You can configure the
type of selection of the buttons using the web menu or the
assignment function.
Rear Panel
LAN1 port
LAN2 port
(ground) terminal
For signal grounding.
LAN1 (PoE) port
Connect to the network on which the system controller or
LEO is connected (network 1). This port accepts power
using PoE.
CAUTION for LAN port
The LAN port of this unit is to be connected only to the
devices whose power feeding meets the requirements for
SELV (Safety Extra Low Voltage) and complies with Limited
Power Source according to IEC 60950-1.
LCD buttons
Rotary encoders
(ground) terminal
When connected to LEO, the settings of the LCD buttons
are made from LEO.
Rotary encoders
The function of each encoder is set by LEO.
CAUTION
When you connect the LAN cable of the unit to peripheral
device, a shielded-type cable is strongly recommended to
prevent malfunction due to radiation noise and
electrostatic noise.
LAN2 port
Connect to the network with system controller connected
(network 2).
5
DC IN connector