Table of Contents
Advertisement
6 Commissioning
The following sections describe how to make the settings for optimum operation of the sys-
tem, comprising the monitor and video source.
The video source for example can be a PC with graphics card, or a diagnostic imaging de-
vice.
6.1 Switching on the monitor
To switch on the monitor, proceed as follows:
•
Switch on the monitor using the power switch.
Note: The power switch is located on the back of the monitor, to the right next to the
connection panel cover.
•
Wait until the operation LED in the front panel of the monitor turns green.
6.2 Using a screen saver
Image sticking may occur with LCD monitors. Image sticking is an effect whereby a faint im-
age of the previous screen contents can be seen after the display contents have changed.
This occurs in particular when the same image content is displayed over an extended period
of time.
You can prevent image sticking by using a screen saver with image content that changes
regularly.
6.3 Selecting the LUT
In the OSD LUT menu, you can select from among five predefined LUT settings and one
"user" setting. The saved values are shown in a table in the OSD window.
The predefined LUT settings saved in the monitor can be changed or updated using QA
software.
Note
Additional information is available in the QA software instructions for use.
CuratOR EX190
Instructions for Use, 06/2022
Commissioning
6.1 Switching on the monitor
23
Advertisement
Table of Contents
