Table of Contents
Advertisement
4 Setup and installation
CAUTION
Changes to device
Do not make any mechanical or electric changes to the device. Otherwise the device war-
ranty becomes invalid.
The manufacturer is not liable for changes made to the device.
4.1 Installation site
Note the following conditions at the installation site.
NOTICE
The power switch and connections must be accessible at all times
When installing and connecting the monitor, ensure that the power switch and the connec-
tions are accessible at all times.
NOTICE
Condensation
If the device is brought into a warm environment from a cold one, condensation may form
in the device. This could result in a short circuit when switching on the device, damaging it.
• Wait until the condensed water has evaporated, including that inside the device, before
you switch it on. This can take several hours.
Sufficient ventilation
Ventilation holes are located on the rear of the housing.
If the ventilation holes are covered or closed, the heat generated in the monitor will not be
dissipated sufficiently.
•
Do not cover the ventilation holes.
•
Do not close the ventilation holes.
•
The minimum distance from the top, back, and side of the monitor to the wall must be at
least 10 cm, and at least 15 cm from other heat-emitting devices.
Avoid dusty environments
The monitor is intended for use in the clean environment of medical diagnostics. In dusty
environments, ventilation holes in the back can allow dust to penetrate into the monitor. In
the worst case, deposits are possible which become evident as dark spots in a white picture
and result in deterioration of the luminance.
•
Protect the monitor from dust, for example through appropriate construction measures at
the installation site.
•
During transport, use the original packaging or service packaging.
CuratOR EX190
Instructions for Use, 06/2022
Setup and installation
4.1 Installation site
15
Advertisement
Table of Contents
