Table of Contents
Advertisement
6
Commissioning
Note
Factory settings
All monitors are optimally preset in the factory, meaning that changes are not usually re‐
quired.
6.1
Switching on the monitor and PC
The monitor and PC can be switched on in any order.
Requirement
•
The PC and monitor are connected to one another via DVI-I cable.
•
TO obtain the best possible results, graphics cards and drivers should support communi‐
cation via the Display Data Channel (DDC).
Switch on monitor before PC
1. Switch on the monitor.
The operation LED lights up yellow.
2. Switch on the PC.
If the connected signal can be displayed on the monitor, the operation LED will light
green.
Switch on PC before the monitor
1. Switch on the PC.
2. Switch on the monitor.
If the connected signal can be displayed on the monitor, the operation LED will light
green.
Note
Operation LED does not light green?
If the operation LED does not light green after the equipment has been switched on and a
video signal has been applied,
check the system for basic connection and operating errors before contacting service per‐
sonnel.
6.2
Avoidance of image sticking
Image sticking may occur with LCD monitors. Image sticking is an effect whereby a faint im‐
age of the previous screen contents can be seen after the display contents have changed.
The following measures can reduce or prevent image sticking:
RadiForce LX300W
Instruction for Use, 03/2014
Commissioning
6.1 Switching on the monitor and PC
25
Advertisement
Table of Contents
