Table of Contents
Advertisement
ADDITIONAL INFORMATION
The projector stops responding to all controls
‡
If possible, turn off the projector, then unplug the power cord and wait at least 20 seconds before
reconnecting power.
Remote control problems
If the remote control does not work
‡
Check the operating angle of the remote control is pointed within ±30° (horizontally or vertically) to the
IR receivers on the projector.
‡
Make sure there are not any obstructions between the remote control and the projector. Move to within
10 m (32.8 ft) of the projector.
‡
Make sure batteries are inserted correctly.
‡
Replace batteries if they are exhausted.
Warning indicators
LED status indicators
The LED status indicators are located on the rear of the projector. Each LED is defined below.
Message
Standby State
(Indicate on Power key)
Power on (Warm up)
Power on & Laser diode
on
Power off (Cooling down)
AV mute is off (Image is
displayed)
AV mute is on (Image is
black)
Projector communication
Firmware upgrade
Laser diode time has
expired
Unit loses over 60% initial
luminance
Error (Over temperature)
Error (Fan failure)
Note:
Keypad LED (Power Key) will flash in orange for standby mode.
64
English
Light LED
Green
Orange
Red
—
—
—
—
—
—
Steady
—
—
—
—
—
Steady
—
—
Steady
—
—
Steady
—
—
—
—
—
Steady
—
—
Flashing
—
—
—
—
—
—
—
—
Status LED
Green
Orange
Red
—
—
Flashing
—
Steady
—
Flashing
—
Steady
—
Steady
—
Flashing
—
Flashing Flashing
—
—
—
—
Steady
—
—
Flashing
—
—
AV Mute LED
Green
Orange
—
—
—
—
—
—
Steady
—
—
—
—
—
Steady
—
—
Steady
—
—
Steady
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
Advertisement
Table of Contents
