Optoma ZU1050 User Manual page 43

USING THE PROJECTOR
WLAN
Configure the wireless local area network (WLAN) settings.
‡ Enable: Enable/Disable WLAN.
‡ Start IP: Start of IP Address.
‡ End IP: End of IP Address.
‡ Subnet Mask: Assign Network Subnet Mask.
‡ Gateway: Assign Network Default Gateway.
‡ MAC Address: Display network MAC Address value.
‡ SSID: Assign Network Service Set Identifier.
Network
Configure the general network settings.
Projector Name: Display the projector hostname for Network.
‡
‡ Restart Network: Restart the network.
‡ Network Factory Reset: Perform factory reset on the network settings. The Projector Name, LAN IP,
WLAN IP, and SNMP settings will be reset
Serial Port Baud Rate
Baud rate is the time of the data transmission. Select the serial port baud rate and make sure the OSD's setting is
same as the device's setting.
Serial Port Path
Select the serial port path from either RS232 or HDBaseT.
Projector ID
Set the projector ID. ID definition can be set up by menu (range 0-99), and allow user control an individual projector
by using RS232 command.
IR Control
Set the IR settings on or off. User is able to control the communication between projector and remote control/HD
BaseT depending on the IR settings.
‡ Front: Enable or disable the Front IR Sensor.
‡ Top: Enable or disable the Top IR Sensor.
‡ HDBaseT: Enable or disable the remote control for HDBaseT.
43
English