Scan Options; Hold/Resume Programming - Kenwood TM-701A Instruction Manual

4-4-7, Memory Shift
Using this function you can copy the contents of a memory
channel or call channel to the VEQ without changing the
data in memory. This will allow you to change the tone data,
or tune normally if you wish.
146.180
1. Press the MR key or CALL
key to select the appropri
ate mode.
&
96.100 :
sah +3 8 era *
2. Press the F key momentar-
ily. The F indicator witt
light.
3. Press the VFO key within
10 seconds of pressing the
F key. The F indicators will
turn off to signal the data
has been successfully
transferred to the VFO.
Note:
@ 4-5. SCAN
4-5-1. Scan Options
The following scan options sre available:
Band Scan
Scan proceeds over the entire band. This function operates
in the VFO mode only.
Band Scan
Progremmable Band Scan
The VHF scan range in this mode is specified in memory
channels 13 and 14.
The UHF scan. range in this mode is specified in memory
channeis 15 and 16. This function operates in the VFO mode
only.
Memory Channel Scan
Scan proceed thru those memory channels that have data
stored and have not been locked out. This function oper-
ates the in MR mode only.
Dual Scan
Scan proceeds alternately between the last VHF and UHF
channels that eppeered in the display. This function oper-
ates In the VFO mode, the MR mode, and the CALL chan-
nel mode.
Scan can not use in conjunction with the Tone Alert System.
4-5-2. Hold/Resume Programming
Two type of scan hold/resume have been provided in this
transceiver. —
Time Operated Scan
You may prefer that the radio stops on a busy channel and
remains there approximately 6 seconds, and then continues
to scan even If the signal is still present.
23