Kenwood TM-701A Instruction Manual page 9

DIM
This function is used to select the intensity. of the front
panel display iWumination. {t is used in conjunction with
the F key, i.e. press the F key and then the LOW/DIM
key to alternate between High and Low display inten-
sities.
6 Microphone connector
Attach the supplied microphone to this connector. The
pin out of the connector is described in the accompany-
ing illustration.
(@) GND (7) GND (Microphone sudio)
MIC '
cannes oe Audie utp (i) VFO key
2 ( 100 mV/10 k \y
(Push to Tath) Approx mito
Ka Thia key is used to return to VFO operation after operat- .
ing in the MR or CALL channel mode. Pressing this switch
+ OWN will allow the tuning control and microphone UP/DOWN
(a UP keys to increase or decrease the operating frequency.
Prese and hold the key for longer than 1 second to initi- .
(5) 8 VOC (Max 150 mA} ot 'ate VFO ecan. Pressing the key after scan has been in-
itlated will cause scan to stop.
~ Pressing the key within 10 seconds of pressing the F key
_,° will copy the' memory channel or call channel date (to he
7 \t VEO. This allows you to change parameters of that chan-
, nel without actually changing the data that has been
stored In memory.
_—? Pressing the F key for longer than' 1 second and(then)-
pressing the "VFO key will cause radio to toggie the
hold/resume mode between Time me Operated scan arid Car-
* oN ~ tler Operated scan.
Ca? yee a