Kenwood TM-701A Instruction Manual page 15

after a microprocessor reset. If the display shows incom-
plete data or you think the displayed frequency is in error
you should reset the microprocessor using the instructions
provided in the Microprocessor Memory Initialization on page
20.
3. Rotate the VOL control clockwise until a signal or noise
is heard coming from the speaker.
4, Rotate the tuning control or press the microphone
UP/DWN switches to select an open channet. Then ro-
tate the SQL control clockwise until the noise just dis-
appears and the BUSY indicator turns off. This point is
known as the Squelch Threshold point. The squelch con-
trol must be adjusted to this setting for the Scan func-
tions to operate properly.
5. Select the desired operating frequency using the micro-
phone or tuning control. When a signal is received the
S-meter will deflect and the BUSY indicator will turn On.
CAUTION: a .
Turn off the transceivers POWER switch before you start
or stop you vehicles engine, or home power supply.
4-2-2. Frequency Selection
You can change the dial frequency while in the VFO mode.
The frequency can then be also be stored in memory, or in
the call channel! using the techniques that will be described
in this manual.
the band can not be selected.
VFO mode
MR key VFO key VFO key CALL key
MA key
[MEMORY channet mode —= CALL channel mode
CALL key
¢ VFO Mode Operation Frequency Selection
1. Press the VFO key to select the VFO mode.
2. Rotate the tuning contro! or press the microphone
UP/DOWN switches to select the desired frequency.
* Memory Channel Selection
1. Press the MR key.
2. Rotate the tuning control or press the microphone
UP/DOWN switches to select the desired memory channel.
© CALL Channel Selection
Press the CALL key to select the Call channel.
4-2-3. Frequency Step Selection
The frequency step is indicated in the chart below.
> Bier 10 «+ 16 20 +> 12.5 «> 265 «,