Kenwood TM-701A Instruction Manual page 14

(6)
(7)
(8)
@)
14
MR key
This key function just like the MR key on the front of the
radio.
PF (Programmable Function) key
This key can be programmed to perform any of the fol-
towing functions:
BAND key (tnitial setting from the factory); or MHz key;
or SHIFT key; or TONE key; or REV key; or LOW key.
To program the key use the following procedure:
1. Turn the POWER switch on the transceiver OFF.
2. Press and hold the key on the front | panel of the
set that corresponds with the function you wish
to program the microphone key to perform.
3. Turn on the POWER switch while the key on the
front panel is held in. ~
4. Release the front pane! key.
One additional function can be programmed that is not
included on the front panel of the transceiver. This is
known as the MONITOR function. This will allow you to
open squeich, to check the band for a clear frequency.
This will function even if you are operating in the CTCSS
decode mode.
MONITOR programming
Press and hold the F key on the front panel as you turn
on the POWER switch of the transceiver and then release
the F key.
16-Tone OTMF keypad (U.S.A. version onty)
These buttons are used to activate the DTMF encoder.
See 4-6-4. for further information on their use.
LOCK key
This Key will deactivate all functions of the microphone
except the PTT function and DTMF keypad.
@ 4-2. RECEIVER OPERATIONS
Audio confirmation is provided whenever a front panel key
is depressed. You can disable this function by gressing the
E_key for longer thant 1_second and then pressing the
REV/STEP key.
4-2-1. RECEPTION
1. Connect the power supply, antenna, and microphone and
then adjust the controls as follows:
Power Switch OFF
Vol Control Full Counterclockwise
Power switch of power supply OFF
(Fixed Station)
SQL Control Full Counterclockwise
2. Turn on the Power Supply and then turn on the tran-
sceivers POWER switch. The display should indicate a
frequency, Fig. 1 shows examples of frequencies that
will appear on the various models. In addition to the fre-
quency you may see one or more control indicator turn
on in the display.