Kenwood TM-701A Instruction Manual page 10

If you press and hold the VFO key while you turn on the
POWER switch you will¢esey the microprocessor's VFO
memory, without destroying the memory channel or call
channel data.
(2) MR key
This key is used to select MR (Memory Recall) mode from
the VFO mode. The tuning control can then be used to
select the desired Memory channel.
Pressing the key for longer than 1 second will initiate
memory channel scanning.
Pressing the ke key within 10 seconds of pressing the F key
will store the displayed data into memory.
in the MR channel mode pressing the F F key for longer
than 1 second and then pressing the MR key will cause
the Memory channet td skip }uring Memory channel scan
mode.
If you hold and press this key while you turn on the POW-
ER switch you will clear all the microprocessor's, opera-
tor programmed, memory section.
® MHz key
This key is used to tell the microprocessor that you wish
to increase or decrease the operating frequency in 1 MHz
increments.
Pressing this key within 10 seconds of pressing the F key
will cause the key lock function to activate, protecting
the currently displayed data from accidental erasure.
(4) Call key
10
Press this key to activate the call channel function.
Press the F key momentarily and then press the CALL
key to store the currently displayed data into the CALL
channel. The radio will allow you up to 10 seconds to
press the CALL key after pressing the F key.
the CALL key after the F begins fleshing the
microprocessor will assume that you pressed the key in
error and cancel the function. You will have to start over
again if the F indicator turns off.
To operate the transceiver with the RC- 10 press and hold
the CALL key on the rraneeeet and then turn on the
POWER switch. Foes
ed ti
& GHIF TAL TONET.ALT REVSTEP BANODUP
1 2) 3) 4
@ SHIFT/AL key
SHIFT funciion
Pressing this key alone to select the desired transmitter
offset direction. Pressing the key will cause the radio to
shift from one offeet direction to the other, i.e." +"
to ''-'' to simplex where no indicator shows. (''-"' to
atunetion ALERT - ( Rron
Pressing the.£ key momentarily and then «easing the
SHIFT/AL key will cause the radio to activate the
ty Alert function. When this function is active the radio
will scan the contents of memory channel 1 at approxi-