Kenwood TM-701A Instruction Manual page 11

\
'2) TONE/T.ALT key
mately 5 second intervals. If there is activity on the fre-
quency a beep will sound from the speaker. Pressing the
same key sequence again will cancel the function.
Pressing the F key for longer than 1 second and then
pressing the SHIFT/AL key will store the currently dis-
played data as the upper limit for the programmable VFO
tui limit function.
ning Tasse Blonre Velee | Ou ~
Pressing this key by itself causes the radjo.to select the
desired tgne signallin When the'T"' indicator is
illuminated in the display the transceiver will transmit the
selected subaudible tone. When the "'CTCSS" indicator
is ituminated the transceiver will both transmit the subau-
~~"'dible tone and will also remain squelched ut until the proper
subaudible tone is received.
if you press the F key momentarily and then press the
TONE/T.ALT key "the(T-ALT¥unction will be activated.
This function will cause the radio to emit a series of beeps
when an incoming signal i is received that will open the
squelch. The function will work with bot or without the
CTCSS option installed.
TONE frequency selection +
Prassing the E key for longer than one second and then
pressing the TONE/T.ALT key will allow you to select the
desired tone frequency. The display will indicate the cur-
rent Tone frequency. To change to a different tone fre-
quency rotate the tuning coi control or press the .UP/DWN
switches on n the microphone until the desired tone fre-
quency appears in the display. To caturn to the formal
frequency display you can press any front panel key @: e@x-
cept the power switch. ~~~
@ REV/STEP key bee ¢ f of F
This key is used to reverse the transmit/receive frequen-
cies during repeater operations. If you have selected sim-
plex this key will not function |
Pressing the F key momentarily and then the REV/STEP
key will allow you to select the desired VFO
and Scan step size. Use the tuning control to the
desired tuning step and then press ress any front panel key
except the POWER switch to return to the normal 'fre-
quency display.
—7 Pressing the F key for longer than 1 second and then
pressing the REV/STEP key will turn the BEEP function
OFF or ON.
(4) BAND/DUP key
THE i" emer Glee | 1b,
This key is used to change bands.
Pressing the FE kay momentarily and then the BAND/DUP
key will cause the duplex function to activate.
—
1