Kenwood TM-701A Instruction Manual page 7

@ 3-2. CONNECTION
3-2-1. Mobile Installations
Cautions:
1. Before installing the power cable disconnect the nega-
tive lead from the battery for safety.
2. After installation and wiring have been completed go
back and check your work to ensure that you have not
made any errors, before you reconnect the negative bat-
tery lead.
3. if the fuse opens be sure to check that each conductor
is undamaged, then replace the fuse with one of the same
rating.
4. After completing the wiring, wrap the fuse holder with
heat resistant tape to protect against heat and moisture.
5. Do not remove the fuse even if the power cable is too
long.
A. Battery Connections
Connect the power cable diractly to the battery terminals.
Use of the cigarette tighter socket will lead to a poor con-
nection, and will result in poor performance. Pay close at-
tention to the polarity of the cables when connecting them
to the battery. Remember Red is positive and black j is nega-
tive |
(h™ Passenger compartment
From passenger
Gea ==
Thread tke this
B. Ignition Noise
3-2-2. Fixed Station
PS-50 are recommended.