GEM 533 eSyStep Operating Instructions Manual page 45

12.4.24 Basic settings
The different settings are summarized with the Basic settings parameter.
Index Sub- Off- Access
In- set Rights
dex
0x50 1 0 R/W
2 1 R/W
3 2 R/W
4 3 R/W
Description of parameter values
Index name
Basic settings Inversion of LED col-
On site initialization
IO-Link process data
www.gemu-group.com
Length Index name
1 bit Basic settings
1 bit
1 bit
1 bit
Parameter Values
ours
Operating mode
Parameter Type
Inversion of Boolean
LED colours
On site Boolean
initialization
Operating mode Boolean
IO-Link process Boolean
data
0 (Standard) LEDs Close = green and Open = yellow (not in-
versed).
1 (Inversed) LEDs Close = yellow and Open = green (inversed).
0 (Enabled) On-site initialization (see "Initialization", page 54)
activated.
1 (Disabled) On-site initialization (see "Initialization", page 54)
deactivated.
0 Operating mode for positioner activated.
1 Operating mode for OPEN/CLOSE control activated.
0 (Disabled) Use of IO-Link process data (see "Process data",
page 30) is deactivated.
1 (Enabled) Use of IO-Link process data (see "Process data",
page 30) is activated.
45 / 64
12 Specific data IO-Link (pin 6)
Default Values
0 0
1
0 0
1
0 0
1
0 0
1
Description
GEMÜ 533 eSyStep
Positioner (Code S0)