Figure 123. Installing the internal USB memory key
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4. If you are replacing the IDSDM module,
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
Figure 124. Removing the IDSDM module
Next steps
Replace the IDSDM
module.
Installing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
120
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
remove the MicroSD
Safety
instructions.
Before working inside your
system.
system.
cards.
system.