Table of Contents
Advertisement
Figure 94. Installing the optical drive blank
Next steps
1. If removed,
install the front
2. Follow the procedure that is listed in
Removing the optical drive
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. If installed,
remove the front
4. Disconnect the power and data cables from the optical drive.
NOTE:
Ensure that you note the routing of the power and data cable on the side of the system as you remove them
from the system board and drive.
Steps
Press the release tab and slide the optical drive towards the front of the system.
bezel.
After working inside your
Safety
instructions.
Before working inside your
bezel.
system.
system.
Installing and removing system components
99
Advertisement
Table of Contents
