Installing The Boss S2 Module - Dell E76S Installation And Service Manual

Figure 110. Installing the BOSS S2 module blank
Next steps
Replace the BOSS S2 module.

Installing the BOSS S2 module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. If installed, remove the front
5. Disconnect the cables connected to the system board.
Steps
1. If installed, remove the BOSS S2 module blank using a flat head screwdriver.
Figure 111. Removing the BOSS S2 module blank
2. Align the BOSS S2 module to the BOSS S2 slot on the chassis and push it into the slot.
3. Using a Phillips 2 screwdriver, secure the BOSS S2 module to the system.
Safety instructions.
Before working inside your
bezel.
system.
Installing and removing system components 113