Siemens SITRANS L Operating Instructions Manual page 46

Procedure
The first steps of the wizard are the same for all application types. The subsequent
parameters of the wizard differ depending on the selected application. Three
separate lists follow for documentation purposes. These lists contain the parameters
of the wizard that are available for setting up each type of application.
1.
2.
3.
4.
5.
Note
A reset to factory settings should be carried out before starting the " Quick
Commissioning Wizard" if the device was previously used in another application.
The settings for the wizard are interrelated and changes only take effect if you set "
Confirm" to " Yes" in the last step.
Do not use the " Quick Commissioning Wizard" to change individual parameters. Only
carry out the adaptation to your specific application after completing the wizard.
While the device is being configured using the assistant, the output remains active
and continues to respond to changes in the device.
In the following steps of the assistant, a complete list of options appears for each
parameter. Depending on the selected application, certain options may not appear
on the device.
SITRANS LR150
Operating Instructions, 10/2022, 62711-76-01, A5E50352155
In the measured value view, press key " → to reach the parameter view. The first
menu level (QUICK START) appears. Push key " → to call up this menu.
Press the " → button again to start the " Quick Commissioning Wizard".
(COMMISSION). In the wizard, it is not necessary to press the " ↓ button to
navigate to the next step. In each step you will be taken directly to the edit view.
Set " Operation" followed by " Material type". The following parameters of the
wizard vary depending on the selected application.
Select " Yes" to confirm all parameter changes as the final step in the Quick
Commissioning Wizard and return to the parameter view. The main line of the
display shows " DONE".
Press the " ← key three times to return to the measured value view.
Setup with the integrated HMI
7.5.1 Wizards for quick setup
37