Epson Powerspan 2 User Manual page 55

System board options (continued)
Option
Cache Control
Onboard
Floppy
Controller
Diskette A
Diskette B
Onboard IDE
Hard Disk
Controller
Settings
Cache Enabled-
Write Through Mode
Cache Enabled-
Write Back Mode
Cache Disabled*
Enabled*
Disabled
35 inch 1.44MB drive*
3.5 inch 720KB drive
3.5 inch 2.88MB drive
5.25 inch 1.2MB drive
5.25 inch 360KB drive
Diskette A Disabled
3.5 inch 1.44MB drive
3.5 inch 720KB drive
3.5 inch 2.88M B drive
5.25 inch 1.2MB drive
5.25 inch 360KB drive
Diskette B Disabled*
Enabled
Disabled*
Running the EISA Configuration Utility 3-13
Description
Set to Enabled-Write Through
Mode to enable caching on
the 486DX2/66 CPU card; set
to Enabled-Write Back Mode
to enable caching on any of
the single or dual-Pentium
CPU cards set to Disabled to
prevent caching when you
are using time-dependent
software. You can also turn
cache control off and on
using the EISA System Utilities;
see Chapter 4.
Set to Enabled to use the
built-in diskette drive
controller; set to Disabled to
disable the built-in controller
and use a controlleron an
option card
Set to the type of diskette
drive installed as drive A in
yours system; set to Diskette A
Disabled if you have removed
yourdiskette drive
Set to the type of diskette
drive installed as drive B in
your system; set to Diskette B
Disabled if you did not install a
second diskette drive
Set to Enabled to use the
built-in IDE hard disk drive
controllerto control your IDE
drive(s); set to Disabled to use
an external IDE drive controller
or the built-in SCSI controller
(1)