Epson Powerspan 2 User Manual page 32

SETUP program options (continued)
Option
Onboard SCSI
SCSI BIOS
Mapping
User Definable
Drives
Video Type
640 x 480 Mode
Refresh Rate (4)
2 - 6 Running the SETUP Program
Settings
Disabled*
H/W/ Only
Enabled
C0000H*
C8000H
EC000H
2 and 3*
48 and 49
VGA/EGA*
CGA40
CGA80
MDA
Not Installed
60 Hz*
75 Hz
x2, x16 @ 72 Hz
(72 Hz in 2 and 16
color modes only)
Description
Select Disabled if you are not
using the built-in SCSI controller
to free up interrupt IRQ11; select
H/W Only if you will not boot your
system from a SCSI device
connected to the built-in SCSI
controller; select Enabled if you
will boot from a SCSI device
connected to the built-in SCSI
controller (2)
If you enabled the Onboard SCSI
option, you must ensure that the
SCSI BIOS location does not
conflict with the onboard video
BIOS location; set this option to a
different starting addressthan
the Onboard Video BIOS
Mapping option address,
described on page 2-12
Select the pair of user-definable
drive types you want to use to
enter your drive's parameters;
select the type and enter the
parametersusing the Hard Drive
option described above; note
that you configure drives 2 and 3
using the EISA Configuration
utility only
Select the type of adapter you
installed; if you are using the
built-in adapter, select VGA/EGA
(3)
Select the refresh rate
(frequency in Hertz) of the built-in
video controllerwhen it is
operating in 640 x 480 mode; see
your monitor manual to
determine the refresh rate your
monitor is capable of displaying