Table of Contents
Advertisement
Chapter 2
Running the SETUP Program
The SETUP program allows you to configure your computer
and set many different system options. Use SETUP to configure
your computer only in the following situations:
You did not install any option cards or installed only ISA
option cards that did not come with configuration (CFG)
files
You are not going to use the built-in SCSI subsystem
You do not have a diskette drive or have disabled your
diskette drive.
In all other cases, use the EISA Configuration utility instead of
the SETUP program to configure your system. See Chapter 3
for instructions on running the EISA Configuration utility.
Note
If you plan to operate your computer without a monitor,
keyboard, or diskette drive, see "Using Special
Configurations" in Chapter 4 before running SETUP or
the EISA Configuration utility. If you'll be redirecting your
computer's input and output to a serial port, be sure to see
"Operating Your Computer from a Remote Location" in
Chapter 4 before configuring your system.
Running the SETUP Program
2-1
Advertisement
Table of Contents
