Epson Powerspan 2 User Manual page 54

If you add any EISA option cards to your system, various
configuration options for the card(s) appear on the screen
following the system board options. See your EISA option card
documentation for information about configuring your card(s).
The table below describes the settings available for each of the
system board options. The numbers in parentheses refer to
notes at the end of the table.
System board options
Option
System
Processor
Module
System Board
Extended
Memory
System Base
Memory Option
User Definable
Hard Drives
3-12 Running the EISA Configuration Utility
Settings
[processor type]
[memory size]
Extended Memory
640KB Base Memory*
512KB Base Memory
Types 2 and 3*
Types 48 and 49
Description
Displays the type of processor
module installed in yours system
Displays the amount of
extended memory in the
system including memory
installed on SIMMs and any
memory option cards you
cannot change this setting
Select 640KB to use all of this
memory as base memory;
select 512KB to reassign the
memory addresses from 512KB
to 640KB if you install an option
card that uses these
addresses
Select the pair of user-
definable drive types you
want to use; select the type
and enter the parametersat
the appropriate Hard Drive n
option(s) described below