Epson Powerspan 2 User Manual page 44

You need to run the EISA Configuration utility to configure
your system with your EISA option cards installed before you
use your computer. You may need to run it again later if you
add or remove options, such as memory, disk drives, or option
cards.
After running the utility, you save the current configuration in
the computer's CMOS RAM and in a file called SYSTEM.SCI.
Your computer checks this information each time you turn it
on and assigns system resources based on the configuration
options you selected.
Once you configure your computer with this utility, you should
not use the SETUP program in your computer's BIOS. Always
use the EISA Configuration utility to configure your computer.
If you want to create an alternate configuration for your
computer or another computer, you can create an alternate SCI
file. See page 3-29 for more information.
Note
The first time you configure your computer, you must run
the program from the System Configuration diskette and it
is best to always run it from there. However, you can run the
EISA Configuration utility from your hard disk to speed up
its performance. See page 3-36 for information on copying
the files to your hard disk. Then see page 3-31 for
instructions on running the utility from a command line.
3-2 Running the EISA Configuration Utility