Table of Contents
Advertisement
2.
Remove the drive from the bay and place it on an anti-static
surface.
3.
If you are removing one IDE drive but leaving another in
the system, you need to change the jumper settings on the
remaining drive. See the documentation that came with
your drive for instructions on changing the jumpers.
4.
Replace the IDE drive bay assembly as described below.
Replacing the IDE Drive Bay Assembly
Follow these steps to replace the IDE drive bay assembly:
1.
Position the assembly so the components on the drive(s) face
down and the screw hole in the assembly faces up.
2.
Insert the anchor tabs on the back of the assembly into the
slots in the computer's side wall, as shown below.
a n c h o r t a b
Installing and Removing Disk Drives
7-13
Advertisement
Table of Contents
