General Setup Using The Smt; Ethernet Port Settings; Figure 5-1 Smt - Port Settings; Table 5-1 Port Settings Fields - ZyXEL Communications ZyXEL EES-1024AF User Manual

5.1 Ethernet Port Settings

Ethernet port connections can be in half-duplex or full-duplex mode. The Ethernet port must use the same speed or
duplex mode setting as the peer Ethernet port in order to connect.
Enter 2 from the main menu, and then type in the port number to bring up the Port Settings menu for the specified
port.
At the prompt, type the corresponding numerical numbers to configure. The Port Settings fields are explained in
the table below.
# FIELD
0.1 Link
0.2 Speed/Duplex
1 Port Enabled
2 Speed/Duplex
3 Flow Control
4 Back Pressure

General Setup Using the SMT

General Setup Using the SMT
[Main] [Ports Settings]
module: 0, port: 1
0.1 Link (RO):
0.2 Speed/Duplex (RO):
1. Port Enabled:
2. Speed/Duplex:
3. Flow Control:
4. Back Pressure:
5. VLAN Tagged:
6. Default VLAN ID:
7. Note:
Q. Quit
Select one function (1-7, Q):

Figure 5-1 SMT - Port Settings

Table 5-1 Port Settings Fields

This read-only field indicates the connection status of the port.
This read-only field shows the actual speed and the duplex mode of the
port.
Select this option to enable or disable the port.
Set the port speed and duplex mode with this option. The switch will auto
detect the speed and duplex mode of the attached device if you select
Auto; otherwise check the settings of the device attached to this port and
select from the following: 100/Full, 100/Half, 10/Full, and 10/Half.
When this option is enabled, the switch sends a PAUSE message to the
device to pause the transmission when the buffer in the switch is full. This
works only for devices in full-duplex mode.
When this option is enabled, the switch sends a Back Pressure message to
the device to pause the transmission when the buffer in the switch is full.
This works only for devices in half-duplex mode.
EES-1024AF Intelligent Ethernet Switch
This chapter shows you basic configuration using the SMT.
Up
100/Full
Enabled
Auto
Enabled
Enabled
No
1
DESCRIPTION
Chapter 5
EXAMPLE
Up
100/FULL
Enabled
Auto
Enable
Enable
5-1